Solid State Broadband High Power Amplifier
2162 – BBS2E4AUT
20 – 1000 MHz / 1000 Watts
The BBS2E4AUT (SKU 2162) is suitable for multi-octave bandwidth high
power CW, modulated, and pulse applications. This amplifier utilizes high
power LDMOS devices that provide wide frequency response, high gain, high
peak power capability, and low distortions. Exceptional performance, long-
term reliability and high efficiency are achieved by employing advanced
broadband RF matching networks and combining techniques, EMI/RFI filters,
and all qualified components. The amplifier is constructed within one single
5RU drawer including the forced air-cooling. The system comes standard to
operate from 180-260VAC single phase or can be ordered optionally with a
three phase AC supply.
The amplifier includes a built in control and monitoring system, with protection
functions which preserve high availability. Remote management and
diagnostics are via an embedded web server allowing network managed site status and control simply by connecting the unit’s
Ethernet port to a LAN. Using a web browser and the unit’s IP address (IPV4, IPV6) allows ease of access with the benefit of multi-
level security. The control system core supports hardware encryption, runs an embedded OS (Linux), has a built-in non-volatile
memory for event recording, and factory setup recovery features. The extended memory option allows storage of control
parameters and event logs.
Empower RF’s ISO9001 Quality Assurance Program assures consistent performance and the highest reliability.
Solid-state linear design
Suitable for CW, AM, FM and pulse (Consult factory for other modulation types)
Compact Modular design
50 ohm input/output impedance
Built in Control, Monitoring and Protection functions
High reliability and ruggedness
ELECTRICAL SPECIFICATIONS over temperature conditions (-10 to +50ºC)
Power Output @ 1dB Gain Compression
(Note 2)
Power Gain @ 1dB Gain Compression
Input Power for Rated P
SAT
Gain Flatness / Leveled ALC
Noise Figure @ maximum gain
20-300MHz/300-1000MHz
NF 20/15 dB
Third Order Intercept Point
2-Tone @ 54dBm/Tone, 1MHz Spacing
IP3 +64 dBm
OUT
= 1000W
(without Harmonic Suppression Filters)
dBc
Operating Voltage – (single Ф)
Operating Voltage – (3 Ф)
Power Consumption @ 1000W CW
Notes: 1. CW measurement performed in MGC Mode (Manual Gain Control)
2 .P1dB measurement performed with CCDF Method, IS-95, 1MHz BW.
MECHANICAL SPECIFICATIONS
Weight (Without Harmonic Suppression Filters)
RF Connectors Input/Output
Input: Type-N, Female
Output: Type-7/16-DIN, Female (optional Type-SC, Female)
Built in forced-air cooling system
316 W. Florence Ave.
Inglewood, CA 90301
Ph. 1 (310) 412-8100
Fax. 1 (310) 412-9232
www.EmpowerRF.com
Stock No. 2162
D.S. Rev 1.2 / 08-01-2013
Comments to this Manuals